What are the safety regulations that must be observed when machining centers operate?
1. It is not allowed to leave the work station when the machining center is running. For reasons of leaving, the work bench is placed in the middle position, the tool bar is returned, the parking must be stopped, and the power of the host computer is cut off.
2. Prior to the operation of the machining center, protective equipment should be worn and the cuffs should be tied. No shawls, gloves, ties, and aprons are allowed; female workers should be carried in hats.
3. Check whether the tool compensation, machine zero point, workpiece zero, etc. are correct before starting the machining center.
4. The relative position of each button should meet the operating requirements. Carefully prepare and input numerical control programs.
5. To check the operation status of the protection, insurance, signal, position, mechanical transmission, electrical, hydraulic, digital display, etc., on the machining center, cutting can be performed under all normal conditions.
6. Before the machining center is commissioned, the operating conditions of the lubrication, mechanical, electrical, hydraulic, and digital display systems should be checked. Cutting operations can be performed under all normal conditions.
7. After the machining center enters the machining operation according to the procedure, the operator is not allowed to touch the moving workpiece, the tool and the transmission part, and it is forbidden to transfer or take tools and other articles across the rotating part of the machine tool.
8. When the machining center is adjusted, the workpieces and tools are clamped, and the machining center is wiped, it must be stopped.
9. Do not remove iron directly by hand. Use special tools for cleaning.
10. When abnormal conditions and alarm signals are found, they should stop immediately and ask relevant personnel to check.
2. Prior to the operation of the machining center, protective equipment should be worn and the cuffs should be tied. No shawls, gloves, ties, and aprons are allowed; female workers should be carried in hats.
3. Check whether the tool compensation, machine zero point, workpiece zero, etc. are correct before starting the machining center.
4. The relative position of each button should meet the operating requirements. Carefully prepare and input numerical control programs.
5. To check the operation status of the protection, insurance, signal, position, mechanical transmission, electrical, hydraulic, digital display, etc., on the machining center, cutting can be performed under all normal conditions.
6. Before the machining center is commissioned, the operating conditions of the lubrication, mechanical, electrical, hydraulic, and digital display systems should be checked. Cutting operations can be performed under all normal conditions.
7. After the machining center enters the machining operation according to the procedure, the operator is not allowed to touch the moving workpiece, the tool and the transmission part, and it is forbidden to transfer or take tools and other articles across the rotating part of the machine tool.
8. When the machining center is adjusted, the workpieces and tools are clamped, and the machining center is wiped, it must be stopped.
9. Do not remove iron directly by hand. Use special tools for cleaning.
10. When abnormal conditions and alarm signals are found, they should stop immediately and ask relevant personnel to check.
Tin Box Games,Dominoes Games,Tin Box Packed Dominoes,Metal Box Packed Dominoes
NINGBO PAPER GAMES KINGDOM CO.,LTD , https://www.papergameskingdom.com