Hipot Tester Power Supply Equipment DC High Voltage Generator

 
 

Introduction:

• ZGF Series 60kV to 300kV DC High Voltage Generator is an important equipment for DC voltage withstand test and leakage current test of HV electrical equipment, cables, surge arresters in electriv industry and power supply departments;

• ZGF Series 60kV to 300kV DC High Voltage Generator is developed based on the calibration made by National HV Meterage Station, it accords with the standard "Generation Requirement of Portable DC HV Generator"(ZGF 24003-90);

• The new technology, new material and optimal selected components are applied, It has the advantages of high power, small volume, light weight, good performance and high stability;

 

Specifications:

• Power: AC220V+10%, 50Hz+1%;

• Output voltage indicator accuracy: <1%;

• Output current indicator accuracy: <1%;

• Ripple contain factor: <0.5%;

• 0.75 times output voltage indicator accuracy: <1%, can be locked;

 

Model Selection:

 

Features:

• High reliability: high frequency voltage multi-doubler rectifier, simple circuit, high overload capability, rare fault, without maintenance.

• Small volume: one person can carry the largest DC HV generator (200kV/2mA). Its volume is only 1/(2~5) as the volume of the same kind of equipment made in Japan. It reaches the advanced level in the world.

• Perfect seal by metal housing, high mechanical strength. Its performance will not be influenced by vibration, moisture, dust and meteorological condition.

• Safe, convenience in operation, metal housing grounded. built-in HV terminals.

• There is no high voltage and low voltage connect outside, easy connection.

• Good auto protection function. It can nor be switched on if the HV output knob is not at zero position. Operation is simply. It automatically switch off in over voltage and over current case. There is dam pong resistor inside.It is not necessary to connect damping resistor outside.

• Excellent accuracy: The leakage current at HV side is measured by digital meter accuracy: 1uA, range switch is not required, discharge withstand current measurement function is available at low voltage side, It use precise resistor with good stability to measure high voltage.

Hydraulic Decoiler
The uncoiler is a special equipment for metal plate leveling. It is used for leveling steel plates and uneven plates. It can be used to form unwinding, leveling, shearing production lines and other plate product production lines according to relevant configurations.
The uncoiler is one of the most important equipments in the welded pipe production line. Its function is to support the steel coil by tightening the inner hole of the steel coil; the other is to send the steel belt head by the rotation of the straight machine. Into the leveler.

The uncoiler spindle has two functions, one is to drive the coil to rotate; the other is the tension support of the coil. The realization of the tension is usually accomplished by pushing the inclined block with the cylinder or cylinder mounted with the spindle. The small unit uses more cylinders and the large unit uses more cylinders. The realization of rotation is usually achieved by the motor rotating the spindle through the reducer. of.

Hydraulic Decoiler And Curving Machine

Hydraulic Decoiler,Hydraulic Decoiler Machine,Automatic Hydraulic Decoiler,Steel Decoiling Hydraulic Decoiler

Cangzhou Feiyang Machiney Manufacturing Co., Ltd. , https://www.coldformingmachines.com