JAC Wreckers often need to check the site

The JAC Wrecker is a relatively good brand among the wreckers, and it attracts many people who need to make wrecker purchases every year. However, after the purchase, there are some parts that require the owners to pay attention to the inspection and maintenance, so that the use of the car can be made longer.

1, spark plugs. Spark plugs have a slightly higher temperature requirement, and during the winter, when wreckers are started, the effect of atomization on gasoline is difficult to achieve. Therefore, in the inspection of the spark plugs, a lot of attention must be paid. If not, replace it promptly.

2, injector. Those who are familiar with the wrecker know that after the wrecker has been driven for a certain amount of time, this part of the nozzle will generate a lot of dirt and dust, and it is relatively easy to accumulate carbon powder relative to the throttle gate. Therefore, if you want to increase the use of JAC wreckers, you should always perform deeper maintenance on the injectors. At the same time, on the top of the throttle gate, you must remove the accumulated carbon pollution.

3, clutch. In winter, the clutch of the car is the most prone to problems, and it is often the phenomenon of extinguishment. Moreover, since the winter road surface is generally in a wet and slippery state, once the clutch is extinguished, the car can easily slip. Therefore, the inspection of the clutch must also be done carefully. After the wrecker has traveled 60 to 80,000 kilometers, it must be replaced in time.

4, the battery. Maybe many people will call this part of the market to shop. Actually, it is also a point that needs regular inspection. During the battery check, it is necessary to pay attention to whether there is electrolyte leakage from the inside of the battery on the battery case, and at the same time, check whether there is accumulation of oxides on the top of the battery. Immediately use sandpaper to clean it so that it has enough current to flow when it is started.

Thick Film Electric Heating Circuit is made on stainless steel plate and insulated by insulation layers.

Thick Film Heating Plate and board can heat stainless steel plate and temperature ramp up above 80℃/S.
Compared with other Electric Heating Element for electric water heater, Thick Film Heating Plate is advanced in larger heating area (Heating Circuit uniform covered heating plate), higher power density, faster Temperature Response (above 80℃/S), Longer Life Span (above 10,000 hours), Lower Thermal Inertia and better Heat Transfer Efficiency(≥98%).
Any size and power can be customized.

Thick Film Heating Plate/Board

Thick Film Heating Plate,Induction Heating Plate,Heating Plate ,Adjustable Heating Plate

XINXIANG JIEDA PRECISION ELECTRONICS CO.,LTD , https://www.tubularheater.de